Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 193 / 414

ELECTRIC VEHICLE - BATTERY CHARGER General Information
15
The high-frequency battery charger is automatic and has no external controls. It functions as an integral part of the
vehicles' electrical system and will not work with other electric vehicles. The charger is programmed with a specific
charge algorithm that is appropriate to the specific battery type used in the vehicle. When the charger is connected,
there is a 2 to 5 second delay before charging begins. When the AC cord is connected, the charger performs a start-up
self-test (all three charger status indicators on the front of the charger flash ON at the same time).
The charger supplied with the electric vehicle resolves the most common problems associated with battery charging.
The charger utilizes sophisticated charge termination criterion to shut off automatically, preventing the possibility of
either undercharging or overcharging. The charger accomplishes this by monitoring battery voltage, charge current,
charge time and using strict dV/dt termination criterion.
Batteries should never be left in a discharged state, as this too affects the internal components and can reduce the
capacity of the battery. The batteries should be charged every day they are used. However, the batteries should
not be charged if they have not been used.
USB SERVICE PORT
The ERIC charger has a USB port for use by Club Car authorized technicians for data transfer, reconfiguration,
and updates. Keep the USB port cover in place when the port is not in use.
See USB Service Port Cleaning
and Care on page 15-11.
UL AND CSA LISTING
High-frequency charging system battery chargers have been listed by UL and by the Canadian Underwriters and
meet the criteria of the Canadian Standards Association.
CE COMPLIANCE
This battery charger is compliant with the EU EMC Directive 2004/108/EC.
PLUG AND RECEPTACLE
The charger cord, plug, and receptacle are wear items and should be inspected daily. Visually inspect for cracks,
loose connections, frayed wiring or bent pins; they must be immediately replaced when worn or damaged. Do not
attempt to straighten a bent pin. If charger plug or receptacle show signs of corrosion or the plug is difficult to insert
or remove, check for bent pins, then clean the receptacle contacts and plug terminals with a good electrical contact
cleaner or light coating of WD-40
® brand spray lubricant. The plug should then be inserted and removed several times
to ensure ease of insertion, ease of removal, and good electrical contact.
DANGER
• To prevent fire, immediately replace battery charger DC cord plug and receptacle if the following
conditions exist:
– Plug pins have worn nickel plating and copper is exposed.
– Plug requires an inordinate amount of force to insert into receptacle, especially if accompanied
by a “grinding” feel.
2019 Precedent Villager 2 Maintenance and Service Manual Page 15-3