Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 276 / 414

18
Test Procedures
GASOLINE VEHICLE - TROUBLESHOOTING
AND ELECTRICAL SYSTEM
TEST PROCEDURE 22 – Fuel Gauge
See General Warnings on page 1-2.
NOTE: This is a voltage test.
1. If necessary, see Testing Basics on page 18-10.
2. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
3. Remove the instrument panel to gain access to the back of the fuel gauge. See Key Switch Removal on
page 19-18.
4. Disconnect the orange wire from the fuel gauge.
5. Set a multimeter to 20 volts DC and place the red (+) probe of the multimeter on the blue wire terminal of the fuel
gauge. Place the black (–) probe on the black wire terminal of the fuel gauge
(Figure 18-13, Page 18-34) .
6. Turn the key switch ON. The voltage reading should be battery voltage. If not, check the continuity of the blue and
black wires
(Figure 18-13, Page 18-34) .
7. The orange wire should remain disconnected for this step. With the black probe still on the black wire terminal
of the fuel gauge, place the red (+) probe of the multimeter on the terminal for the orange wire. The voltage
reading should be battery voltage or less depending on fuel level. If the reading is incorrect, replace fuel gauge
(Figure 18-14, Page 18-34) .
2m
20
m
200
m
2k
200
200
200
200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
!
!
COM 200mA
MAX
1000 ---
750V
FUSED
1
I
G
S
18-GAUGE
BLUE WIRE
TO NO. 1 ON
KEY SWITCH
18-GAUGE
BLACK
WIRE TO
GROUND
REAR VIEW OF
FUEL GAUGE
REMOVE
18-GAUGE
ORANGE
WIRE
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200mA
MAX
1000 ---
750V
FUSED
1
I
G
S
REAR VIEW OF
FUEL GAUGE
18-GAUGE
ORANGE
WIRE
2429
Figure 18-13 Fuel Gauge Test
2430
Figure 18-14 Fuel Gauge Voltage Test
Page 18-34 2019 Precedent Villager 2 Maintenance and Service Manual