Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 386 / 414

24
Transaxle Removal GASOLINE VEHICLE - TRANSAXLE
2700
Figure 24-8 Disconnect Rear Shackles
2401
Figure 24-9 Disconnect Front of Leaf Spring
14. Position floor jack under rear crossmember of chassis or trailer hitch mount (if equipped) (Figure 24-10, Page
24-10) . See WARNING “Lift only one end of the vehicle...” in General Warnings on page 1-2.
15. Raise vehicle just enough to relieve weight on leaf springs, then remove bolts securing leaf springs to shackles
(Figure 24-8, Page 24-10) .
16. Remove bolts securing front of leaf springs (Figure 24-9, Page 24-10) .
ClubCar
ClubCar
ClubCar
ClubCar
2402
Figure 24-10 Raise Vehicle
2403
Figure 24-11 Position Jack Stands On Both Sides of
Frame
17. Continue raising vehicle until chassis is higher than the top of the transaxle (i.e. enough to allow powertrain to be
rolled out from under vehicle)
(Figure 24-10, Page 24-10) . Position jack stands, adjusted to support the vehicle at
this height, under the frame crossmember between the leaf spring mounts and side stringers, just forward of each
rear wheel
(Figure 24-11, Page 24-10) . Lower the floor jack to allow the jack stands to support the vehicle.
18. Remove floor jack from beneath vehicle.
19. Grasp ends of leaf springs at rear of vehicle and carefully pull the powertrain until snubber at front of engine pan
is free of the chassis. Gently lower front of powertrain to the floor
(Figure 24-12, Page 24-11) . The powertrain
should be completely disconnected from vehicle and resting on floor.
Page 24-10 2019 Precedent Villager 2 Maintenance and Service Manual