Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 52 / 432

4
Cargo Bed – Electric Lift BODY AND TRIM
4
1 6
6
2
2
3
1
5
2475
Figure 4-4 Driver Seat Belt – Homologated Models
SEAT BELT INSTALLATION – HOMOLOGATED MODELS
1. Driver seat: Install the seat belt buckle assembly and coiled seat belt assembly to the driver seat as shown
with hardware previously removed except for the lock nut (Figure 4-4, Page 4-12) . Use a new lock nut and
tighten to 33 ft-lb (44.7 N·m).
2. Passenger seat: Install the center seat belt buckle assembly to the seat belt bracket with hardware previously
removed except for the lock nut (Figure 4-3, Page 4-11) . Use a new lock nut and tighten to 33 ft-lb (44.7 N·m).
Secure the coiled seat belt assembly on the outside of the ROPS seat support with the shoulder bolt and a new
lock nut
(Figure 4-2, Page 4-11) . Orient the assembly with the tang end pointed up slightly and tighten the new
lock nut to 33 ft-lb (44.7 N·m).
CARGO BED – ELECTRIC LIFT
See General Warnings, Section 1, Page 1-2.
TESTING THE BED LIFT MOTOR
Gasoline Vehicles: See Test Procedure 35 – Bed Lift Motor on page 11-36.
BED LIFT MOTOR REMOVAL
1. Make sure the key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position. Remove the
key. Chock the wheels.
2. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
3. With the bed in the down position, working from under the vehicle, disconnect the two wires from the connectors
at the electric bed lift motor.
4. Remove the locknut, bolt, sleeve, spacers and washers from the rod end of the bed lift motor and bed frame.
Page 4-12 2013 Carryall 295/XRT 1550 Maintenance and Service Manual