Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 353 / 432

DRIVETRAIN COMPONENTS Rear Driveshaft
17
CAUTION
• Do not kink, twist, or damage the hydraulic brake lines.
9. Install both rear wheels and finger-tighten the lug nuts.
10. Lower the rear of the vehicle.
11. Use a crisscross pattern to tighten the lug nuts on both rear wheels. See Wheel Installation on page 8-2.
12. Ensure differential has appropriate type and volume of oil. See Gearcase Lubrication on page 10-15.
13. Gasoline vehicles: Connect the spark plug wires.
14. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
REAR DRIVESHAFT
REAR DRIVESHAFT REMOVAL
See General Warnings, Section 1, Page 1-2.
1. Push the car to a position that enables easy access to the roll pin securing the rear driveshaft to the differential
pinion shaft
(Figure 17-12, Page 17-9) . Chock the front wheels.
2. Disconnect battery and spark plug wire(s) (gasoline vehicles only) . See Disconnecting the Battery –
Gasoline/Diesel Vehicles, Section 1, Page 1-3.
3. Remove the roll pin from the differential pinion shaft and driveshaft universal joint. See following NOTE.
NOTE: Use a 1/4-inch roll pin punch to drive out the roll pin.
4. Slide the driveshaft forward on the transmission to release the driveshaft from the differential pinion shaft. Then
slide the driveshaft toward the rear and off the transmission shaft.
2197
Figure 17-12 Roll Pin in Driveshaft and Pinion Shaft
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 17-9