Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 241 / 432

ELECTRICAL COMPONENTS: GASOLINE
VEHICLES Wire Harness Diodes
13
TESTING THE HEADLIGHT BULB AND SOCKET
See Test Procedure 34 – Voltage at Headlight Socket on page 11-34. See also Test Procedure 33 – Light
Switch on page 11-33.
HEADLIGHT BULB REMOVAL
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. From the front of the vehicle, reach under the cowl and turn the connector harness/halogen bulb assembly
clockwise one-quarter turn
(Figure 13-11, Page 13-17) .
3. Remove the connector harness/halogen bulb assembly from the headlight lens.
4. Lift the retaining tabs on the connector and remove the halogen bulb.
1
2
3
1165
Figure 13-11 Headlight Bulb
HEADLIGHT BULB INSTALLATION
NOTE: When handling halogen bulbs, do not touch the glass portion of bulb. Oil from finger tips can cause premature
failure of the bulb.
1. Attach the connector harness to the halogen bulb. The retaining tab should lock onto the halogen bulb (Figure
13-11, Page 13-17) .
2. From the front of vehicle, reach under the cowl and insert the bulb assembly into the headlight lens.
3. Turn the bulb assembly counterclockwise one-quarter turn.
4. Connect battery and spark plug wire(s). See Connecting the Battery – Gasoline/Diesel Vehicles, Section
1, Page 1-4.
WIRE HARNESS DIODES
See General Warnings, Section 1, Page 1-2.
The wire harness is equipped with several in-line diodes.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 13-17