Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 166 / 432

11
Test Procedures
TROUBLESHOOTING AND ELECTRICAL
SYSTEM: GASOLINE VEHICLES
5. Check for continuity on the switch contacts with the Forward/Reverse handle in the REVERSE position (Figure
11-19, Page 11-23) . The multimeter should indicate no continuity.
6. If any of the continuity readings are incorrect, replace the neutral switch. See Neutral Switch Removal on
page 13-2.
TEST PROCEDURE 16 – Wire Continuity
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. To test a wire for continuity, disconnect either end from the electrical component to which it is attached.
3. Set the multimeter to 200 ohms and place the red (+) probe on the terminal at one end of the wire. Place the
black (–) probe on the other terminal end of the wire. The reading should indicate continuity. If the reading is
incorrect, repair or replace the wire.
See following NOTE.
NOTE: When checking continuity of wires in the wire harness, observe the polarity of diodes. Testing continuity of
certain wires will require the appropriate diode test procedure. See Test Procedure 9 – Wire Harness
Diodes on page 11-18.
TEST PROCEDURE 17 – Front Differential Limit Switch
See General Warnings, Section 1, Page 1-2.
NOTE: Keep the battery connected during this test procedure.
The front differential limit switch is located under the hood where the accelerator pedal mounts to the chassis.
2363
Figure 11-20 Front Differential Switch
1. Disable the vehicle. See Disabling the Vehicle on page 1-3.
Page 11-24 2013 Carryall 295/XRT 1550 Maintenance and Service Manual