Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 389 / 432

HYDRAULIC ATTACHMENT SYSTEM Electrical
19
2. Set the joystick ON/OFF switch to OFF.
3. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
4. Disconnect wires from each post of circuit breaker.
5. Remove hardware securing breaker to chassis and remove breaker.
Circuit Breaker Installation
1. Attach breaker to chassis with screws and tighten to 75 in-lb (8.5 N·m).
2. Connect wires to breaker. Tighten nuts to 75 in-lb (8.5 N·m).
3. Connect battery. See Connecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-4.
4. Lower the cargo bed.
CONTROL VALVES
Two-Way 2-Position Normally Closed Valves
1
2
3
1. Two-Way 2-Position Control Valves
2. Three-Way 2-Position Control Valves
3. Four-Way 2-Position Control Valves
2
1
2
1
2247
Figure 19-31 Control Valve Identification
2248
Figure 19-32 Two-Way 2-Position Valve and Coil
These valves allow for free flow in one direction (from the bottom port to the side ports) at all times and controlled flow
in the opposite direction until the solenoid coil is energized
(Figure 19-32, Page 19-19) .
Troubleshoot and repair these valves as follows:
1. If the valve does not shift, check and repair (if necessary) the following items:
– The valve “hot” wire and ground wire
(Figure 19-19, Page 19-9) .
– The switch controlling the valve. See Electrical on page 19-8.
– The supplied voltage.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 19-19