Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 163 / 432

TROUBLESHOOTING AND ELECTRICAL SYSTEM:
GASOLINE VEHICLES Test Procedures
11
6. Remove the starter relay, carburetor heater relay and, if equipped, the accessory relay from the multi-pin
connector located on the electrical component mounting plate.
7. Set the multimeter to the diode test function.
8. Connect the black (–) probe of the multimeter to the 18-gauge purple wire (w47) at the key switch multi-pin
connector.
9. Connect the red (+) probe of the multimeter to the female side of the carburetor solenoid bullet connector.
10. The reading should indicate an over limit (no continuity). If the diode conducts current (shows continuity) with
the meter probes connected as described, the diode has failed and must be replaced. See Wire Harness
Diode Removal on page 13-18.
11. Reverse the multimeter probes and note the reading. The multimeter should indicate approximately 540 mV,
however, a range of 400 to 700 mV is acceptable.
12. If the readings obtained in the previous steps are incorrect, replace the diode. See Wire Harness Diode
Removal on page 13-18.
TEST PROCEDURE 13 – Diode 4 on wire 130 and 122
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Raise the hood and disconnect the multi-pin connector from the key switch.
3. Disconnect the bullet connector in the carburetor solenoid green wire (Figure 11-15, Page 11-20) .
4. Set the multimeter to the diode test function.
5. Connect the black (–) probe of the multimeter to the frame (ground).
6. Connect the red (+) probe of the multimeter to the female side of the carburetor solenoid bullet connector.
7. The reading should indicate an over limit (no continuity). If the diode conducts current (shows continuity) with
the meter probes connected as described, the diode has failed and must be replaced.
See Wire Harness
Diode Removal on page 13-18.
8. Reverse the multimeter probes and note the reading. The multimeter should indicate approximately 540 mV,
however, a range of 400 to 700 mV is acceptable.
9. If the readings obtained in the previous steps are incorrect, replace the diode. See Wire Harness Diode
Removal on page 13-18.
TEST PROCEDURE 14 – Diode 5 on wire 131 and 129
See General Warnings, Section 1, Page 1-2.
1. Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline/Diesel Vehicles on
page 1-3.
2. Raise the hood and disconnect the multi-pin connector from the key switch.
3. Disconnect the six wire engine harness connector located near the starter (Figure 11-22, Page 11-27) .
4. Disconnect the 16-gauge green wire (w127) from the starter solenoid coil (Figure 11-9, Page 11-14) .
5. Set the multimeter to the diode test function.
6. Connect the black (–) probe of the multimeter to the frame (ground).
7. Connect the red (+) probe of the multimeter to the 16-gauge green wire (w127) at the spade connector.
8. The reading should indicate an over limit (no continuity). If the diode conducts current (shows continuity) with
the meter probes connected as described, the diode has failed and must be replaced.
See Wire Harness
Diode Removal on page 13-18.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 11-21