Club Car Carryall XRT 1550, Руководство по техническому обслуживанию и ремонту

Страница: 341 / 432

DIESEL ENGINE, MUFFLER, FUEL SYSTEM, AND
CLUTCHES Clutches
16
1
2
4
5
3
6
6
"X"
"X"
2175
Figure 16-30 Driven Clutch Assembly
Driven Clutch Assembly
1. Place the fixed sheave (5) onto the spring compression base and note the location of the “X” so that the “X” on
the moveable sheave (4) can be aligned correctly
(Figure 16-30, Page 16-31) .
2. Place the moveable sheave (4) onto the fixed sheave (5) and align the “X’s” on both components.
3. Place the spring (3), cup (2), and snap ring (1) onto the clutch.
4. Place the spring compression collar onto the cup (Figure 16-29, Page 16-30) .
5. Tighten the spring compression nut just enough to enable the snap ring to be installed.
6. Use the snap ring pliers to install snap ring.
Driven Clutch Installation
1. Disconnect battery. See Disconnecting the Battery – Gasoline/Diesel Vehicles, Section 1, Page 1-3.
2. Install the driven clutch assembly on the transmission splined shaft.
3. Install the mounting washer and new retaining bolt. Tighten retaining bolt to 39 ft-lb (53 N·m).
4. Install the drive belt as instructed. See Drive Belt Installation on page 16-25.
5. Install the clutch outer cover and tighten the screws to 72 in-lb (8 N·m).
6. Install the top air filter hose on the filter canister.
2013 Carryall 295/XRT 1550 Maintenance and Service Manual Page 16-31