CLIVET WSAN-YMi 21, Руководство по установке, использованию и обслуживанию

Страница: 67 / 156

67
There are three methods for connecting the thermostat cable and it depends on the application.
Method A
RT can control heating and cooling individually, (4-pipe system)
User interface setting:
THERMOSTAT and ROOM MODE SETTING to YES:
A.1 When unit detect voltage is 230VAC between C and N ,the unit operates in the cooling mode
A.2 When unit detect voltage is 230VAC between H and N, the unit operates in the heating mode.
A.3 When unit detect voltage is 0VAC for both side(L-N, H-N) the unit stop working for space heating or cooling.
A.4 When unit detect voltage is 230VAC for both side(L-N, H-N) the unit working in cooling mode.
Method B
RT provide the switch signal to unit.
User interface setting:
ROOM THERMOSTAT and MODE SETTING to YES:
B.1 When unit detect voltage is 230VAC between H and N, unit turn on.
B.2 When unit detect voltage is 0VAC between H and N, unit turn off.
NOTE
When ROOM THERMOSTAT is set to YES, the indoor temperature sensor Ta can’t be set to valid, unit running only according to T1.
Method C
Hydraulic module is connected with two external temperature.
User interface setting:
DUAL ROOM THERMOSTAT su YES:
C.1 When unit detect voltage is 230VAC between H and N ,the MAIN side turn on.When unit detect voltage is 0VAC between
H and N, the MAIN side turn off.
C.2 When unit detect voltage is 230VAC between C and N, the ROOM side turn on according to climate temp curve. When
unit detect voltage is 0V between C and N), the ROOM side turn off.
C.3 When H-N and C-N are detected as 0VAC, unit turn off.
C.4 when H-N and C-N are detected as 230VAC, both MAIN and ROOM side turn on.
NOTE
The wiring of the thermostat should correspond to the settings of the user interface.
See chapter START-UP AND CONFIGURATION - ROOM THERMOSTAT.
Power supply of machine and room thermostat must be connected to the same Neutral Line and (L2) Phase Line(for 3-phase unit
only).
Room thermostat - Not supplied