CLIVET WSAN-YMi 21, Руководство по установке, использованию и обслуживанию

Страница: 65 / 156

65
Buckling position
Back cover
Front cover
Straight head
screwdriver
Screw hole installed on the three M4X20
Screw hole installed on the three M4X20
Screw hole installed on 86 Electrician box, use two M4X25
Back cover
Signal
switching
wires
Wall installation Installation in electrical box 86
Back cover installation
1) Use straight head screwdriver to insert in the buckling position in the bottom of wired controller, and spin the screwdriver to take
down the back cover. (Pay attention to spinning direction, otherwise will damage the back cover!)
2) Use three M4X20 screws to directly install the back cover on the wall.
3) Use two M4X25 screws to install the back cover on the 86 electrician box, and use one M4X20 screws for fixing on the wall.
4) Adjust the length of two plastic screw bars in the accessory to be standard length from the electrical box screw bar to the wall.
Make sure while installing the screw bar to the wall, making it as flat as the wall.
5) Use cross head screws to fix the wired controller bottom cover in the wall through the screw bar. Make sure the wired controller
bottom cover is on the same level after installation, and then install the wired controller back to the bottom cover.
6) Over fastening the screw will lead to deforma tion of back cover.
Left down
side wire
outlet
Cutting place of left down side
wire outlet