Sys tem Check list & Trou ble shoot ing (Con tin ued)
Num ber of LED flashes
be tween pauses
Trig ger/sen sor in di ca tion
2 flashes
Dual- Zone Piezo Sensor
4 flashes*
Door Trigger*
5 flashes
Trunk Trigger/Hood Trigger (trunk only, if IntelliStart 4 has
been installed)
6 flashes
Hood Trigger (only if IntelliStart 4 has been installed)
7 flashes
An attempt was made to turn the ignition “ON” or start the
engine while the system was armed
10 flashes
Power Interruption
*
If the de layed cour tesy lights fea ture is ac ti vated, this trig ger in di ca tion will not be pro vided.
If the
door trig ger
is in di cated, ac ti vate the de layed cour tesy lights fea ture.
n
No chirps.
If there are no chirps, ver ify that the Chirps fea ture (User-Programming -
col umn 2, row 1) is “On” and check the wir ing con nec tions as noted in the
High Output
Si ren
sec tion on page 11.
NOTE: If none of the troubleshooting techniques described in steps 3 - 7
corrects the problem, perform the following diagnostics:
n
Make sure the fuses are in the fuse hold ers.
n
Check the power and ground con nec tions.
n
Ver ify that the con trol unit con nec tor is prop erly in serted into the con trol unit.
n
Verify that the ig ni tion in put is con nected to the true ig ni tion line instead of a 12V line.
Find the true ig ni tion line by fol low ing the appropriate steps of the
Starter or Ignition
Immobiliza tion Cir cuit
sec tion on page 11.
n
Ver ify that the trans mit ters are pro grammed cor rectly.
NOTE: If the 20A fuse blows upon arm ing:
n
Disconnect the Tazor 4’s two parking light wires, replace the 20A fuse and rearm. If the
fuse blows while the parking light wires are dis con nected, the door locks are not wired
cor rectly. Re con nect the ve hi cle’s power lock ing sys tem to its origi nal con di tion, then
re test the volt ages as in di cated in the
Door Locks
sec tion of this manual and wire the
locks as in di cated, then re place the 20A fuse.
Step 4.
Test the park ing lights.
Arm the sys tem by press ing the
but ton on the re mote con trol.
n
Two flashes.
This is the correct response, proceed to step 5.
n
One flash.
If the parking lights flash only once, the Tazor 4 had pre vi ously AutoArmed
it self pas sively and by press ing the
but ton the sys tem dis armed (re mote dis arm ing
is ac knowl edged with one chirp and one parking light flash). Disarm and rearm the
system.
n
No flashes.
If no flashes, ver ify the parking light bulbs are op era tional. If not, they must
be re placed. If so, re peat steps 1-5 of the
Parking Lights
sec tion of this manual.
n
Only one side flashes.
If only the right or the left side parking lights flash, see the
Parking Lights
sec tion of this manual.
17
