Pas sen ger Com part ment Con nec tions (Con tin ued)
Plain View 2 Coded Valet Switch
1. Discuss placement of the switch with the vehicle owner and avoid placing the switch
where it can be pressed accidentally.
2. Verify there is adequate space behind the selected location to accommodate the switch.
3. Drill a 5/16” (8mm) mounting hole, then insert the wires through the hole and mount the
switch.
4. Mate the switch’s locking connectors to the WHITE and BLACK locking connector.
5. Remove the adhesive backing and press into place.
Dual- Zone Piezo Sen sor
Mount the Dual-Zone Piezo Sensor in the passenger compartment, not in the engine
compartment.
1. Firmly mount the sensor near the base of the steering column (if the steering column has a
rotating sleeve, firmly screw the sensor to the interior firewall, kick panel or trunk wall).
Make certain that the adjustment screw is accessible.
2. Mate the sensor to the connector on the wireloom from the control unit with the BLACK,
RED, ORANGE and BLUE wires.
Trunk Trig ger
Vehicles with a ground-switching trunk light will interface directly with the Tazor 4 (on positive
switching Rolls-Royce vehicles, use a relay to invert polarity). The switch may be located in or
near the trunk latch or at the trunk light. If a switch cannot be located, you must add a pin
switch in a location away from water channels.
NOTE: If the ve hi cle has a dash board trunk ajar in di ca tor, in stall a 1A di ode
be tween the light and switch with the di ode band point ing to ward the
switch.
1. Connect the GRAY/YELLOW wire to the trunk switch (between the diode and switch if
you added a diode).
Park ing Lights
The Tazor 4 has built-in Parking Light relays.
To determine whether the vehicle has single or dual parking light circuit(s), you must access
the fuse panel. A single circuit has one fuse; a dual circuit has two.
Sin gle Park ing Light Cir cuit (Most Japa nese and Ameri can Ve hi cles)
1. Turn on the parking lights and access the Parking Light wiring in one of the following
locations:
n
Near the head light switch
n
In the door sill har ness go ing to the rear lights
n
At any of the four Park ing Light bulbs
2. If working underdash, be sure to turn the dashlight dimmer to its lowest setting.
3. Connect a voltmeter lead to ground and find the single wire that shows +12v when the
parking lights are on and 0 volts when they are off.
4. Connect
both
of the BROWN wires to the parking light wires.
8
