Ta ble of Installer- Programmable Fea tures (Con tin ued)
NOTE 1:
Once this feature is selected, you will hear one chirp to confirm that the
timer has started. You can set this anywhere from one to 4.25 minutes (255
seconds). When the desired duration has been reached, press the unmarked side of
the PlainView 2 switch. You will hear two chirps to confirm the new system timer
duration.
NOTE 2:
After programming either gas or diesel, you must perform the mandatory RPM
programming.
Sys tem Check list & Trou ble shoot ing
The fol low ing check list and trou ble shoot ing tips will as sure that you have in stalled the Tazor
4 cor rectly. If the sys tem does not re act as noted, fol low the trou ble shoot ing tip(s) de noted
with a black box be low that item, then re peat the step. Each suc ces sive step re quires that the
pre vious step has been com pleted as in di cated.
Step 1.
Re-enable the courtesy lights.
In step 1 of the
Important
Information
sec tion at the beginning of this manual, the in te rior
cour tesy lights were disabled. You must now re-enable the courtesy lights by re placing the fuse
you re moved or re set the cour tesy light switch back to its nor mal “DOOR” po si tion bef ore
pro ceed ing.
Step 2.
Test the Im mo bi li za tion cir cuit.
Arm the Tazor 4 (either from inside or outside the vehicle) and wait 10 seconds. Turn the
ignition to the “ON” position.
n
Engine does not respond and alarm triggers.
This is the correct response, proceed to
step 3.
n
Engine starts or cranks.
The immobiliza tion cir cuit has been mis wired. Care fully re test
the ve hi cle wires as noted in the
Starter or Ignition Immobiliza tion Cir cuit
section
on page
11.
n
Engine still starts or cranks after retesting all the wiring as noted on page 11, check the
power and ground connections. Then make sure the fuses are in the fuseholders, verify
the control unit connectors are securely fastened, verify the ignition wires are connected
to the true ignition line instead of a 12V or accessory line, and verify that the
transmitters are programmed correctly.
Step 3.
Test the chirps.
Close all doors and arm the Ta zor 4 by pressing the
button on the remote control.
n
2 Chirps:
This is the correct response. Proceed to step 4.
n
1 Chirp:
If you hear only one chirp, the Tazor 4 had previously armed itself passively
and by pressing the button, the system disarmed (remote disarming is acknowledged
with one chirp and one parking light flash). Disarm and rearm the system.
n
4 Chirps:
If you hear 4 chirps ei ther im me di ate ly or 5-10 sec onds af ter the ini tial two
chirps, a trig ger or sen sor is open or active, or the ve hi cle has de layed cour tesy lights and
the De layed Cour tesy Lights fea ture has not been programmed on. Dis arm with the
re mote con trol, en ter the ve hi cle and turn on the ig ni tion. The LED will flash 1–10
times, pause, then re peat the same number of flashes (the flash cy cle re peats five times
for your con ven ience). Ref er to the following chart.
16
