FACT—False Alarm Con trol and Test
The system microprocessor automatically checks for another activated sensor or trigger before
sounding the siren a second time, thus preventing any further false alarms. If you wish to test
FACT, simply,
1. Arm the sys tem with the re mote con trol.
2. Wait 10 seconds after the interior light turns off, then trigger the Dual-Zone Piezo Sensor
to activate the siren.
3. Do not disarm the system, let the siren complete its cycle.
4. Trigger the sensor again. The alarm should be silent.
5. Unlock and open a door. The alarm should sound immediately. You may now disarm.
Eight- Event To tal Re call
The system’s nonvolatile memory records the identity of the last eight activated or
malfunctioning triggers and sensors.
NOTE: The CliffNet Wiz ard dis plays the Eight- Event To tal Re call data in a
graphi cal for mat.
1. With the ignition OFF, press and hold the unmarked side of the PlainView 2 Switch.
2. Press remote control button 1 to “arm,” and then again to “disarm,” and then release the
button.
3. The LED will flash 1–10 times, pause, then flash 1–10 times, etc. Write down the number
of flashes in each cycle.
4. Refer to the following chart. The first number you wrote down was the most recently
activated trigger or sensor. The next number is the second most recent, and so on up to as
many as the last eight activations.
12
Func tion
Press but ton(s)
Arm/Disarm
Activate Auxiliary A*
(usually remote trunk release)*
Silent Arm/Disarm
+
✱
IntelliStart 4 or Other Wired Accessory*
✱
Activate Auxiliary B*
(such as timed headlight activation)
SmartWindows 4 Accessory*
+
Unassigned*
+
✱
Unassigned*
+
Remote Valet Mode Enter/Exit*
+
✱
Unassigned*
+
*These channels can be assigned to control other Clifford
ACG 2 systems and accessories on the customer’s other
vehicles.
