En gine Bay Con nec tions
High Out put Si ren
Mount the siren in the engine compartment away from hot or moving parts and where it
cannot be reached from under the vehicle, preferably opposite the exhaust system. Point the
siren down to avoid water collection (see the illustration).
1. You must firmly secure the siren to the engine bay firewall or an fender well using all three
sheet metal screws supplied.
2. Us ing the sup plied con nec tor, connect the wireloom’s YELLOW wire to the BLACK siren
wire.
3. Connect the RED wire through the 5A fuse coming from the battery positive cable clamp.
Hood Trig ger
Vehicles with a ground-switching hood light will interface directly with the Tazor 4 (on positive
switching Rolls-Royce vehicles, use a relay to invert polarity). The switch may be located in or
near the hood latch or at the hood light. If a switch cannot be located, you must add a pin
switch in a location away from water channels.
1. Connect the GRAY/YELLOW wire to the hood switch.
Fi nal Wir ing Con nec tions
1. Connect the RED wire to the 5A fuseholder as shown on page 4.
2. Connect the RED/WHITE wire to the 20A fuseholder as shown on page 4.
3. Attach the two fuseholders to the battery positive cable clamp.
4. Attach the BLACK wire to the vehicle battery negative cable clamp.
NOTE: Power and test ac ces so ries af ter the ba sic sys tem has been tested.
In di vidu ally fuse all ac ces sory power con nec tions. In di vidu ally fuse all +12V
con nec tions.
Smart Powe rUp™ 2
SmartPowerUp 2 ensures that the system powers up in the same state (disarmed, armed or valet
mode) it was last in. When you first power up the system, it will silently enter its disarmed state.
De layed Cour tesy Lights
Some vehicles have a courtesy light delay or dimming circuit, which interferes with an alarm being
able to detect the door trigger upon remote arming. If the delay or dimming lasts more than 5
seconds, no special connections or testing are needed, simply turn on the
Delayed Courtesy Lights
feature as noted in the
Installer-Programmable Features
section on page 16. Please note that
since this feature sets the system to arm the instant the courtesy lights are off, the Door Ajar
Warning feature will not be available.
Re mote Con trol Chan nel As sign ments
The Tazor 4 comes with two ergonomically designed remote controls. Up to two additional
Clifford ACG 2 remote controls can be added (older Clifford ACG and non-ACG remotes
are not compatible with the Tazor 4). For instructions on how to use the remote controls,
please refer to the Tazor 4 User’s Manual.
11
