Cleco LIVEWIRE TMEC-200 Series, Руководство по программированию

Страница: 8 / 110

8 P1934E/EN 2009-04
en01c381.fm, 23.04.2009
Getting started
1
1.4.2 Assembly
Each unit is used primarily as a single or multiple tool process/controller/monitor installed in a
work station or work area. It may be wall mounted, table mounted, beam mounted, suspended
overhead, pedestal mounted or used without mounting. Always choose a stable location to avoid
the possibility of unit damage and/or operator injury through hitting, falling, vibration or inconve-
nient mounting. All cables attached to the unit should be located and secured so that they cannot
cause injury to the operator or to passersby. Like all electrical devices, the control system emits
some heat. It should therefore be positioned where air can circulate freely around the housing.
Refer to Illustration "J" of the parts manual PL12-1405 for mounting hole dimensions.
1.4.3 Location considerations
Your unit should be located to allow access to the front panel and connectors. The unit should be
installed for unrestricted and comfortable viewing of the LCD screen by the operator. The LCD
menu screen, key pad and connectors must be readily accessible for the setup. Dependent on
the peripheral equipment purchased, the unit may be located in a remote position but should still
be accessible.
Attachment of accessories and tools should also be considered with the installation locations.
Items to be considered are:
• Location of printer.
• Attachment of a data collection unit, if desired.
• Attachment of remote annunciators, socket nest, or remote parameter select.
• Attachment of the unit in a network to a computer.
• Operation convenience/safety - keep cables off the floor or dangling in operator areas.
1.4.4 Power source
The device acts as process control and power supply unit for Cleco electric nutrunners and
requires a power supply connection of
• 10 A at 115 VAC ±5% (50/60 Hz) or 220 to 240 VAC ±5% (50/60 Hz).
1.4.5 Intended use
The TMEC-200 may be used only under the following conditions:
• Industrial EMC limit value class A.
• Only cables of types authorized by
Apex Tool Group
may be used.
• Furthermore, only accessory parts authorized by
Apex Tool Group
may be used.
• Unauthorized alterations, repairs and modifications are prohibited for reasons of safety and
product liability.