Cleco LIVEWIRE TMEC-200 Series, Руководство по программированию

Страница: 63 / 110

en03c381.fm, 23.04.2009
P1934E/EN 2009-04 63
Programming
3
3.7.5 Infrared data transmission
c00
7
04
en
.bm
p
Fig. 3-24: Communication - Tool 1
The Communication with the Tool area defines the port to which the infrared data transmission is
connected.
IRDA Off Disables infrared data transmission.
IRDA Serial Select this if you want to use a serial interface for infrared data transmis-
sion. Multiple tools of the same controller can use the same serial interface
for infrared data transmission. Once an interface has been enabled, it is no
longer available for other tasks, such as barcode or serial rundown data
transmission.
IRDA Gateway
IP Select this if using a gateway (Ethernet/serial, order no. 961159) for infra-
red data transmission. If you enable this, you have to enter the IP address
of the gateway.
Assign softkey
<F2>
Pressing the Assign softkey <F2> assigns the connected tool to the
selected tool number. An assignment is possible only if a connection exists
to the tool. An assignment deletes any existing rundown data in the tool.
Delete Assign-
ment
softkey
<F3>
Pressing the Delete Assignment softkey <F3> deletes the assignment of
the tool serial number to the selected tool number.
NOTE
If this tool was assigned to a different system, a reassignment is also necessary, as otherwise
data consistency cannot be guaranteed.