1891b-enu_1_5_bedingt.fm, 25.04.2014
P1891E/EN 2014-02
9
Safety
1
1.5
Designated use
The 47BA is designed exclusively for fastening and releasing threaded fasteners.
The communication with the controller is allowed only over the following interface ports:
Do not use it in areas where there is a risk of explosion.
Do not open it or modify it structurally.
Only use with accessory parts which are approved by the manufacturer
(see 4 Accessories, page 17).
Do not use as a hammer or for re-bending.
1.6
Norms / Standards
It is mandatory that national, state and local codes and standards be followed.
Other type-specific standards, see 11 Technical data, page 73.
1.6.1
FCC conformity
This device complies with Part 15 of the FCC Rules. Operation satisfies the following two prerequisites: (1)
the device does not cause any impermissible failure, and (2) the device accepts failure, including failures
which cause unwanted operation of the device.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
1.6.2
Canada conformity
Operation satisfies the following two prerequisites: (1) the device does not cause any impermissible failure,
and (2) the device accepts failure, including failures which cause unwanted operation of the device.
1.6.3
EMC
Industrial environment EMC limit class A.
The tool complies with the following EMC standards:
DIN EN 61000-6-4 Emitted interference
DIN EN 61000-6-2 Interference immunity
DIN EN 60601-1-2
1.7
Noise and vibration
Emissions sound pressure (i.e. noise) level Lp < 68 dB(A) free running (i.e. without load) complies with
DIN EN ISO 60745:2010-01.
The vibration values < 2.5 m/s² are in accordance with DIN EN ISO 20643:2005-03
Types
Communications
All
IrDA interface port of the tool holder, order no. 935290
47BAR(…)
RF868 MHz
47BAX(…)
WLAN standard IEEE 802.11b WEP, WPA/WPA2
47BAY(…)
WLAN standard IEEE 802.11a/b/g WEP, WPA(2), LEAP, PEAP
47BAZ(…)
WPAN standard IEEE 802.15.4
