Cleco LiveWire P1891E, Инструкция по эксплуатации

Страница: 49 / 88

1891e-enu_TroubleShooting_bedingt.fm, 25.04.2014
P1891E/EN 2014-02 49
Troubleshooting
9
9 Troubleshooting
Problem Possible cause Measure for mPro400GC
(SW S168813) Measure for mPro400S…
(example SW 168841)
1)
1) Software-dependent measure. Discrepancy possible when using Custom Tool Software.
General tool
Tool doesn't start with
counterclockwise rota-
tion activated. With counterclock-
wise rotation, parame-
ter for speed is set to
0 1/min.

Parameterize Speed left rotation
On the control screen Standard >
Standard Application Builder > Tool
Groups
On the control screen Main Menu
> Application Builder > Tool
Groups
Tool light disabled. Disabled by parameter
setting.

Parameterize the
tool light
On the control screen Advanced >
Tool Settings > LiveWire Settings
 Press < > on the control.

Select the required tool under
TM Unit # >
Tool Assign-
ment
.

Press < >.

Make selection under Nutrun-
ner
Lighting Function
.
Control menu on tool
not enabled or only
partially enabled. Disabled by parameter
setting.

On the control screen
Advanced > Tool Settings >
LiveWire Settings
, mark the
check box
Enable Tool
Menu
or use the drop down list
F1 Button on Tool
to
assign the left function key
<F1>.

Press < > on the control.

Select the required tool under
TM Unit # >
Tool Assign-
ment
.
 Press < >.

Select function under
Con-
trol Button Settings
.
Default = Control menu
disabled.
Idle speed not
reached. Battery voltage is too
low.

Use fully charged battery.
Expected number of
test rundowns is not
achieved with one
charge of the battery. Battery is not fully
charged.

Use fully charged battery.
The warning threshold
for undervoltage is not
set to minimum value.

On the control screen Tool
Setup > Tool Settings , reduce
the
Undervoltage (V)
.

Press < > on the control.

Select the required tool TM
Unit # > under
Tool Assign-
ment

Press < >.
 Under
Energy Management
reduce the
Undervoltage
Threshold
.
High torque is needed
during a fastening
sequence, e.g. for
coated fasteners. If a high torque is needed for a longer period of time, e.g. for several
turns, the number of rundowns that can be achieved with one battery
charge will be significantly reduced.
Battery has too many
charging cycles. After 800 charging cycles the capacity is reduced to approx. 60%.