Apex Tool Group GmbH
P2398PM | 2018-12
51
Tightening sequence
4
EN
Parameters
Explanation
Range of values
Speed (rpm)
Speed selection: In the range of the
maximum speed specified in the tool
constants, with validity at the beginning
of the sequence up to the threshold
torque.
Begin: With tool start
End: Threshold torque
± Maximum speed
Final speed (rpm)
a
a. The maximum torque is not normally reached. The torque shutoff value is less than the maximum torque.
Therefore, it is not completely regulated to the final speed.
Speed when the maximum torque is
reached. Must be less than the starting
speed (rpm).
As soon as the threshold torque is
reached, the speed is reduced from the
starting speed to the final speed at the
maximum torque. With increasing
torque, the speed drops.
Begin: From the threshold torque
End: Shut-off torque
± Maximum speed
Maximum angle (deg)
Upper limit of attained angle.
0 … 9 999
Maximum torque (Nm)
Upper limit of attained torque.
0 … 1.2 x TQ capacity
Minimum angle (deg)
Lower limit of attained angle.
0 … 9 999
Minimum torque (Nm)
Lower limit of attained torque.
0 … TQ shut-off torque
Threshold torque (Nm)
Beginning of angle counting.
0 … TQ capacity
Shut-off torque (Nm)
Valid monitoring torque during the tight-
ening process. If the monitoring torque
is exceeded, the drive stops immedi-
ately.
0 … TQ capacity
Shut-off angle (deg)
0 ... 9999
