Apex Tool Group GmbH
P2398PM | 2018-12
13
Menus and Functions
3
EN
3.4
Run screen
The run screen displays the rundown data for the tightening sequence. The appearance of the run screen
differs depending on whether the mPro mode or the FastApps mode is selected.
For both modes, the following applies:
•
Green background: The result of a tightening sequence is OK.
•
Green-blue flashing: The overall result for all the tightening positions (batch) is OK.
•
Red background: The result of a tightening sequence is NOK.
•
Flashing red: The overall result of all the tightening sequences is NOK. This is the case if at least one
tightening position is NOK.
3.4.1
Run screen in the mPro mode
The linking group for the tightening sequence is selected in the mPro mode on the controller.
Abb. 3-2: Run screen in the mPro mode
Symbol
Description
Linking group/Batch display
Number of tightening positions for a Linking group.
•
If there is only one Linking group, then each result is evaluated.
•
If there is more than one Linking group, the overall result of all the tightening posi-
tions is considered.
Example: 2/3
•
Current tightening position: 2
•
Total number of tightening positions: 3
Display of the torque for the current tightening.
If an arrow pointing up appears next to the symbol, the result is too high.
If an arrow pointing down appears next to the symbol, the result is too low.
Display of the angle for the current tightening.
If an arrow pointing up appears next to the symbol, the result is too high.
If an arrow pointing down appears next to the symbol, the result is too low.
27°
3/3
τ
12
Nm
|
