cleasby FIBERGLASS Series, Инструкция по эксплуатации

Страница: 59 / 112

CLEASBY CONVEYORS MAINTENANCE & SERVICE
INSPECTION LIST
Customer Name: Inspection Date:
Address: Work Order #:
Phone: Truck #:
O.S.H.A. INSPECTION REQUIREMENTS: O.S.H.A. 1926.550 requires that an employer shall perform daily and monthly
inspections and maintain results of inspections for each hoisting machine and piece of equipment. It further requires that
a thorough annual inspection of hoisting machinery be made by a competent person, or by a government or private
agency recognized by the U.S. Department of Labor; and that the employer maintain a record of the dates and results of
inspections of each hoisting machine and piece of equipment. The following are suggested inspection items to perform
on Cleasby conveyors, turntables and stabilizers in order to comply with O.S.H.A Regulation 1926.550.
GENERAL INSTRUCTIONS: All inspections listed should be performed as schedule indicates. Daily inspections do not
have to be recorded but should be verified and recorded monthly. A copy of completed form should remain with
conveyor at all times.
If you do not understand these instructions, or if you are not sure whether or not a part
should be replaced, please call the manufacturer; Cleasby Conveyors, 1-800-453-2446
D = Daily
W = Weekly
M = Monthly
S = Semi-
Annually
INSPECTION DESCRIPTION
P = Pass
F = Fail
REPAIRED
YES/NO
DATE
Conveyor Model # Serial #
D Check safety and warning decals for legibility and replace if necessary
D Check conveyor mounting pin and brass bushing for excessive wear
D
Check hydraulic hose and fitting for leaks and replace only with orange
NON-CONDUCTIVE hydraulic hose
D Check instruction tube at the bottom side of conveyors for manual
D Check on/off belt control valve for smooth operation
W Check loading guard. Replace if damaged or bent
W Check nose loops for wear and replace if necessary
W Check roof support legs and pins and replace if missing
W Check chain and sprocket guard and replace if missing or damaged
W Clean conveyor to eliminate conductive contaminates
M Inspect fiberglass channel for cracks, excessive wear or holes
M Check conveyor saddle for wear or cracks in welds or metal
M Check drive chain and sprockets for alignment or excessive wear
M Check tail pulley wheels, bushings, shaft and take up plates for wear
M Check drive drum wheels, bearings, shaft and grease if necessary
M
Check belt for excessive wear, cracks and tension and replace with
only a
NON-CONDUCTIVE PVC belt
M Tighten all nuts and bolts
M
Check all cleats on belt to make sure nuts and bolts are tight. Replace
any cleats that may be missing.
M Check belt return rollers and tracking guides for excessive wear.
Cleasby Conveyors * 362 S. Main * Clearfield, Utah 84015 * (800) 453-2446
Page 1 of 3
(801) 773-1311 FAX: (801) 773-8608