cleasby FIBERGLASS Series, Инструкция по эксплуатации

Страница: 47 / 112

Cleasby Conveyors Operating Instructions
Cleasby Conveyors (Rev. 08/14/12) | Page 3-1
OPERATING FEATURES
These operating instructions apply to the
RTH series of fully hydraulically-
operated turntables. The FBR Fiberglass
constructed conveyors are used with the
RTH turntables.
Before attempting to operate the
conveyor/turntable, READ and
familiarize yourself with the “General
Instructions Section” of this manual
.
Fig. 3-1 Hydraulic Controls Mounted on
Center Post
The RTH series turntable comes with a
full range of hydraulic functions (see
Fig. 3-1).
There are four (4) controls which govern
the flow of hydraulic fluid in support of
various operating functions:
► Conveyor Lift
► Conveyor Rotation
► Belt Power
► Raising and Lowering Post
The standard hydraulic system (CM)
provides employs a direct drive pump
and reservoir that the installer connects
to the truck transmission by a PTO.
Never drive the truck or race the
engine while the PTO is engaged. The
pump operates at the correct speed,
and produces sufficient oil flow when
the truck engine is idling. Driving the
truck or racing the motor may
damage the pump.
Hydraulic fluid lines connect the pump
to valves on the turntable post. As load
is placed on the system, the pressure
correspondingly increases to
accommodate the resistance. The factory
has pre-set the pressure relief valves in
the system to provide enough power to
operate the unit at full capacity while
keeping the pressure within safe
operating limits. If the unit does not
operate properly with the pre-set
pressures, the system either: (1.) is being
incorrectly operated; or (2.) there is a
problem in the hydraulic system. Advise
your maintenance for correction. The
hydraulic system also incorporates a
variety of flow restrictors and check
valves. Never operate the turntable and
conveyor if any of these safety control
devices has been removed or is missing.