cleasby FIBERGLASS Series, Инструкция по эксплуатации

Страница: 56 / 112

Cleasby Conveyors Maintenance and Service
Cleasby Conveyors (Rev. 08/14/12) | Page 4-4
Preparation for Storage
When the conveyor will remain unused
for more than one month, conduct the
following maintenance before placing
the unit in storage:
1.) Clean the truck, conveyor, and
turntable thoroughly.
2.) Perform the weekly and monthly
maintenance described above. Maintain
the truck as recommended in the owner’s
manual.
3.) To prevent rust, oil all exposed
cylinder rods with the same grade of
hydraulic oil specified for use in the
system.
4.) Order any replacement parts
required, and schedule any maintenance
necessary to prepare the unit for the next
season.
.
UNIT REPLACEMENT
In addition to the required periodic
servicing and maintenance detailed
above, note that certain parts of the
conveyor need periodic replacement.
Important:
Read the special
instructions for belt and hydraulic line
replacement for FBR conveyors
located at the beginning of the
manual
. Although (CM) employs every
effort to assure that customer
expectation of performance is exceeded,
from time to time however, it may be
necessary to replace components
following extended use. As is the case
with any mechanical system,
components ware out. The rapidity with
which this occurs is a function of a
number of factors, including
environmental conditions, extremes in
hot and cold or damp conditions. Also
and most significantly, hours in service
and the nature of use rather light,
moderate or heavy. These and other
factors all come to bear in predicting
component longevity.
Cleasby Conveyors, recommends that
you replace certain parts before they fail.
A complete failure of certain
components may create a safety hazard
or cause extensive damage to other
costly parts. The following replacements
are highly recommended when a careful
inspection indicates excessive wear or
damage:
1.) It is very important that you see to it
that the safety and warning labels placed
on the conveyor and turntable at the
factory are always readable. If not, they
must be replaced. Replacement labels
are available, free of charge from either
your dealer, distributor or directly from
the factory.
Risk of DEATH or SERIOUS
INJURY if the Conveyor or Load
comes in Contact with or Proximity to
Power Lines
Never replace Hydraulic lines with
metal or rubber substitutes
The Belt Must Not be replaced except
with an IDENTICAL belt that must
be ordered from Cleasby Conveyors
(800) 453-2446
2.) As a result of exposure to the
elements, the rubber hydraulic hoses on
the conveyor will deteriorate even if the