cleasby FIBERGLASS Series, Инструкция по эксплуатации

Страница: 31 / 112

Cleasby Conveyors Mounting Instructions
Cleasby Conveyors (Rev. 08/14/12) | Page 2-1
GENERAL
The following instructions describe a
step-by step process for mounting the
conveyor and turntable. (CM)
recommends that an experienced
installer professionally mount your
conveyor and turntable. With proper
mounting, you may anticipate may years
of reliable service. Conversely, improper
installation may damage the equipment
and actually make it hazardous to
operate
.
NOTE:
Cleasby Conveyors STRONGLY
Recommends installing truck-bed
stabilizers on all trucks carrying
truck-mounted conveyor units
The quality of construction of the truck
bed and method of attachment of the bed
to the truck frame are important factors
underlying a quality installation. On the
contrary, an improperly constructed or
mounted truck bed will usually give poor
service, and may in fact shorten useful
life. Moreover, such compromised
fabrication may damage the conveyor
and /or turntable and make them
hazardous to operate.
Parts Supplied by (CM)
(CM) completely assembles, aligns and
tests each conveyor and turntable at the
factory prior to shipping. In addition,
each turntable is painted with a high-
visibility, weather-resistant paint for
protection. Each unit is furnished, fully
equipped with all necessary parts. (CM)
also provides WARNING LABELS that
MUST be placed in the cab and bed of
the truck on which the conveyor and
turntable are to be mounted.
NOTE:
Cleasby Conveyors is not responsible
for any loss or damage resulting from
improper installation of either the
truck bed or the conveyor and
turntable
The turntable is mounted on a pallet and
shipped, fully equipped with all
necessary valves, fittings and hydraulic
hoses.
(CM) provides in addition, a piton-type
hydraulic pump, oil storage reservoir,
and all mounting bolts to secure the
turntable to the truck bed.
The installer may choose to use a
different pump and oil reservoir.
Substitution is acceptable, if the
capacities and pressures match with
those of the overall system. These
instructions describe the procedures for
mounting (CM)’s standard package. The
mounting may vary somewhat with a
different pump system.
(CM) ships the stabilizer package with
the stabilizers completely assembled and
fastened to a pallet with the main
mounting bracket. (CM) also includes a
two-spool hydraulic valve and valve
mounting bracket in the set, and tack two
support tubes in place into the open end
of the stabilizer mounting bracket
(remove and discard the support tubes
when the unit is mounted on the truck).