cleasby FIBERGLASS Series, Инструкция по эксплуатации

Страница: 40 / 112

Cleasby Conveyors Mounting Instructions
Cleasby Conveyors (Rev. 08/14/12) | Page 2-10
raised or lowered from the head board of
the rack.
Bleeding the System
1.) Start the truck engine and engage the
PTO with the engine running at idle.
Run the engine for a few minutes to
warm-up the oil. Then engage the
hydraulic motor on the conveyor in both
directions (fore and aft) to expel air from
the system. Run all other hydraulic
functions (except swing) in both forward
and reverse directions to likewise
discharge trapped air in the system.
2.) Take special care when bleeding the
hydraulic swing function. Gently feather
the flow with the valve through the
rotation motor until the oil has
completely circulated through the
circuit. Repeat in the reverse direction.
Warning Labels and Safety
Devices
1.) There are a variety of warning
labels, cover guards, safety valves,
restrictors and other safety devices
installed on the conveyor and turntable
for your protection. For instance, the
Stop Valve (part #12AN) connected to
the conveyor lifting cylinder part
(prevents the conveyor boom from
falling when elevated, in the event of a
hydraulic hose or connection failure.).
DO NOT remove any warning labels
or safety devices.
If a hydraulic function
does not operate properly, check for
plugged ports, and determine if the
safety valves or restrictors require
cleaning. If these steps fail to resolve the
difficulties, contact your local dealer or
call (CM) for assistance.
2.) The hydraulic system has various
pressure relief valves to prevent damage
from excess pressure. These relief valves
are of a type that are non-adjustable, and
pre-set at the factory.
DO NOT alter or
modify in any way. The system
operating parameters established via
these valves is sufficient and proper to
operate the conveyor and turntable.