cleasby FIBERGLASS Series, Инструкция по эксплуатации

Страница: 53 / 112

Cleasby Conveyors Maintenance and Service
Cleasby Conveyors (Rev. 08/14/12) | Page 4-1
GENERAL
This section contains instructions for
maintaining and servicing, (1) FBR
conveyors; (2) RTH 3000, RTH-4000
and RTH-6000 full hydraulic turntables.
The service record card included with
these operating instructions shows the
factory recommended maintenance
schedule. Also use this card to keep
track of maintenance and repairs
performed.
(CM) engineers its conveyors to provide
years of service in for heavy, continuous
use. With proper maintenance, the
conveyor system will work when you
need it.
Failure to maintain your conveyor and
turntable will cause it to wear out faster
then it normally would.
Always perform the scheduled
maintenance before putting the conveyor
in service
.
NOTE
Only trained, qualified personnel
should perform maintenance and
adjustments.
ROUTINE MAINTENANCE
Daily Maintenance
Inspect each conveyor and turntable unit
daily before leaving the yard. Inspect (1)
the conveyor boom; (2) all hydraulic
hoses and fittings, and (3) the turntable
post and head for cracks, splits or other
damage. Inspect all steel pins, nuts and
bolts (including (a) the pins that connect
the conveyor saddle to the post; (b) the
pins that connect the cylinders). Make
sure the right nuts and cotter pins that
keep these items in place are securely
attached. Check all fittings for leaks and
clear the truck bed of all oil residue.
Similarly, inspect stabilizers.
Weekly Maintenance
Service each conveyor and turntable unit
weekly while in use. Schedule a specific
day in the week to perform maintenance,
preferably before leaving the yard. It
should take about ten to fifteen minutes
to complete. Follow the ten-point service
program as listed below:
1.) Maintain tire pressure as specified
on the truck tire side walls. Be sure all
tires on the truck are the same size;
2.) Inspect hydraulic hoses, valves,
motors and fittings for leaks or damage,
tighten, repair or replace, as necessary;
3.) Keep the valve bank clean and free
from obstructions. Replace valve
handles when rubber becomes worn and
clear the truck bed of all extraneous
material and oil;
4.) Grease the inner turntable post to
avoid abrasive wear. Always keep the
post well-lubricated. Lubricate using
only a good grade of lithium-based all-
purpose grease.
5.) Grease the pin used to hinge the
conveyor saddle or platform to the