13
CLEARSPAN
™
STORAGE MASTER
Revision date: 05.08.19
Assemble the End Frame
After the ground posts are set, assemble the remainder of
the end frame.*
• Angled Bracket (QH1330)
• Carriage bolts and nuts and Tek screws (FA4482B)
• QH1404 band clamps and 104074 brackets
• 2" x 2" square tube (105328) and 104075 inserts
• 1.5" x 1.5" square tube (end wall frame)
*Refer to the End Wall diagrams for door framing and
connecting hardware.
Diagrams shown are specific to an
10' x 9' overhead door.
Complete the following steps:
1. Using the dimensions on the End Frame diagrams (or
for the doors if equipped) and the
2" x 2" square tubing
(105328)
, related hardware, and connectors, assemble
the door frame of the end wall.
NOTE:
The dashed lines above show where to install
the 2" x 2" square tubes. Consult the End Frame
diagram to properly position and connect the brackets.
The lower end of each 2" x 2" main door frame vertical
slides over each 1.75" x 1.75" ground post set in
concrete. Secure the connection by installing Tek
screws on the back or inside surface of the verticals.
To avoid damaging the end panel (if equipped) or
conflicting with an overhead door installation (if
equipped) do not install Tek screws from the outside or
within the door opening.
Splice the joints of the 2" x 2" tubes using a 104075
(1.75" x 1.75") square tube insert for each splice. Install
Tek screws to secure each splice.
2. After the 2" x 2" door framing is installed, repeat the
steps to assemble the remaining end wall framing
using the 1.50" x 1.50" square tubing (102897) and the
related connectors.
NOTE:
The dashed lines and arrows identify the
remaining end frame members to install. These are the
1.5" x 1.5" square tubes. (Some tubes must be cut to
length.)
Secure each tube splice using a Tek screw. Install
the screws in a position that will not interfere with the
installation of additional end frame components or the
end panel.
Position the center vertical installed between the door
header and the peak of the end rafter as needed to
avoid conflicts with the clamps and main shelter frame
components attached to the end rafter. See the End
Frame diagram for a similar comment.
ATTENTION:
When installing the overhead door,
remove the center vertical between the header and the
base rail within the opening of the of the door.
3. Repeat the steps to assemble the remaining end wall
frame.
4. After assembling the end wall frames, read the special
note about the door frame that follows before installing
the end panels.
Ground Level
2" x 2" Tubes
2" x 2" Tubes
