Clarke PRO-MIST DURA, Инструкция и список запасных частей, Страница: 22 / 133

19
PRO-MIST DURA® ULV
Sleeve Removal and Replacement
The efficiency of the sprayer is largely a function of the
cleanliness of the Hub and Sleeve assembly. It is
ALWAYS
a better choice to replace a sleeve that is suspected of
being clogged rather than cleaning it.
Though it may be possible to get some additional life
out of a sleeve by gently and carefully cleaning it, it is
not recommended. If any imbalance, defects or damage
is identified the sleeve must be discarded and must not
be used.
Using a sleeve that is in poor condition increases the
risk of the sleeve coming apart at high speed causing
unnecessary risks and damage.
Removal and Reinstallation of the
Hub and Sleeve Assembly
Removal from Spray Head
It is critical that the Hub and Sleeve assembly
is removed from the spray head motor prior to
attempting a sleeve change.
The specially designed Spanner Puller tool is necessary
to accomplish a Sleeve change without damaging the
precision components within the high speed motor.
Follow the specific steps described to remove,
change and replace this critical part of the machine.
The following tools are needed:
• Green “Spanner/Puller” Tool (included
with Pro-Mist Dura)
• ½” Wrench
Using 1/2” Wrench loosen nut carefully
and remove from Shaft.
If needed the hex socket feature on the
Spanner Puller tool can hold the shaft
steady while using the wrench to loosen
the nut. Be careful not to damage the
threads of the shaft.
Loosen and remove the nut with fingers.
SPRAYER MAINTENANCE
NOTE: To avoid damaging the motor, DO NOT
attempt to remove the sleeve while the hub is
on the motor. Always remove the hub to replace
the sleeve.
1
2
3