Clarke PRO-MIST DURA, Инструкция и список запасных частей, Страница: 125 / 133

122
SMARTFLOW II
Error Codes — Err 1
(Cont.)
GREEN LED CODES
Green LED off and Red LED off No 24 VDC to motor controller possible
RED LED CODES BLINKING SEQUENCE FAULTS
Over voltage error • • • Excessive battery voltage
Under voltage error • • • • Low battery voltage
Over Temp warning • • • • • Motor controller temp is above 90° C
Fail to start, no RPM • • • Possible excessive load
Internal Volts Fault • • • • Check all voltage/s RPM signal lost in respect
to ground VDC.
Frequency reset • • • • May be caused by over voltage, bad motor
Internal reset • • • • • Can be caused by momentary over current
of high/low battery voltage; can happen
during normal operation.
Throttle Error • • • • • • Bad throttle signal
Encoder Error • • • • • • Internal spray head problem or poor
connection.
TROUBLESHOOTING
NOTE: If the Spray Head is not running and increasing the rpm setting has no effect see below information
on fault codes to help identify the issue. If no Green LED or blinking red LED codes (in the pump box) are
displayed, go to “Check 2” to investigate a possible issue with the 24 volt supply.