Clarke PRO-MIST DURA, Инструкция и список запасных частей, Страница: 115 / 133

112
SMARTFLOW II
Startup/Shutdown
Step by Step SmartFlow II Operation
1. Make sure SPRAY button is in OFF position on
the SmartFlow II console.
2. Place RATE switch in position RATE 1, RATE 2
or RATE 3 .
3. (No need to turn on the power switch on the console
as the power switch automatically defaults to the on
position.)
You must turn on main ON/OFF switch,
located on the rear of the actual machine.
4. Turn the SPRAY HEAD switch to the ON position.
You should hear the blower motor start up as well
as the spray head. Allow the speed to ramp up to
the target speed (typically 28,000). Allow a cold
spray head several minutes to warm up before
turning on this spray pump.
5. When ready to start spraying move SPRAY switch
to
VAR
or
CON
located on the console.
Variable
Mode is used with a GPS option to track the
vehicle speed while adjusting the pump speed
to maintain consistent coverage, regardless of
consistency of speed.
Continuous Mode
maintains
a constant volume/min delivered to the spray head.
(Continuous Mode speed is determined by the CONT
SPEED in calibration settings).
6. When done spraying flip SPRAY switch to OFF .
Allow the sleeve to spin dry for a minute.
7. Shut off Spray Head
8. Flip POWER switch to OFF position. (This switch
will again default to the ON position, but by this
time, the main on/off breaker switch on the
machine will trip to the off position.
SPRAY
VAR
CONT
OFF
RATE
RATE 1
RATE 2
RATE 3
SPRAY
VAR
CONT
OFF
ON
SPRAYHEAD
SPRAY
VAR
CONT
OFF
POWER
ON
OFF
OPERATION