Clarke PRO-MIST DURA, Инструкция и список запасных частей, Страница: 19 / 133

16
PRO-MIST DURA® ULV
15D
Connect the power leads to the vehicle
battery terminals.
Connecting the Pro-Mist Dura to Your Vehicle's Electrical System (Cont.)
With these cables connected to the rear of the SMII control console determine the best mounting location within
the cab. The included SMII mounting bracket can be used to secure the console within the cab. It is recommended
to secure the console for safety purposes.
16D
Connect machine's onboard battery to the
Promist’s power plug.
Verify all electrical connections are clean and secure.
Reset breaker to allow vehicle charging system to deliver
power to the machine’s onboard battery.
INSTALLATION
1. Verify that the Vehicle’s battery and the sprayer’s “on
board battery” are in good condition, (Fully charged and
Load tested).
2. Verify all cabling that is used to deliver Power and Ground
to the machine is of the proper gauge, a multi stranded
6 Awg cable or larger is recommended. All connections
must be clean and tight.
3. Verify both ends of the positive cable have sufficient fuse
or breaker protection to prevent excessive vehicle damage
if inadvertent damage and/or an electrical short occurs
along its length.
4. Verify the vehicles charging system is sufficient to keep up
with not only the sprayer’s power consumption but also
any lighting accessories and air conditioning that could
affect the consistency of the available power.
5. Ideally a depleted battery should be brought up to full
capacity slowly, using a low amp trickle charger. This is
to prevent overheating and potential damage to both the
connection points and the battery itself.
6. Some newer vehicles may have different power saving
modes that can drastically effect both the occurrence and
performance of the charging system. This is sometimes
referred to as “Tow Mode” or “RV Mode”.
7. To achieve optimum and consistent sprayer performance,
it is important to verify that the charging system and
batteries that you connect will meet and ideally slightly
exceed the sprayer’s power requirements.