© 2006 Directed Electronics—all rights reserved
17
Connect this wire to the second ignition or accessory wire in the vehicle. (Selectable by using Feature 9.)
NOTE:
For vehicles that do not have a second ignition or accessory wire, this connection is not
required.
remote engine start harness (H2), 5-pin
connector
Connect this wire to the toggle (override) switch as shown in Figure A. Connect the other wire from the toggle switch
to the PARK/NEUTRAL switch in the vehicle. This wire will test with ground with the gear selector either in PARK or
NEUTRAL. This will prevent the vehicle from accidentally being started while in a drive gear. This input MUST rest at ground
in order for the remote engine start system to operate. Connected properly the vehicle will only start while in PARK or
NEUTRAL.
In some vehicles, the PARK/NEUTRAL position switch activates a factory starter lock-out that will not allow the
starter to operate in a drive gear. In these vehicles, connect this wire to the toggle switch as shown in Figure B.
Connect the other wire from the toggle switch to chassis ground.
Figure A
Figure B
IMPORTANT!
Always use the Vehicle Safety Check section of this guide to verify that the vehicle
cannot be started in ANY drive gear and that the override switch is functioning properly.
This input provides the module with information about the engine's revolutions per minute (RPMs). It can be con-
nected to the negative side of the coil in vehicles with conventional coils. In multi-coil and high energy ignition
H2/2 VIOLET/WHITE tachometer input
H2/1 BLACK/WHITE neutral safety switch input
PINK/WHITE (+) output to second ignition/accessory circuit