26
© 2006 Directed Electronics Vista, CA
transmitter/receiver learn routine
The system comes with one transmitter that has been taught to the receiver. The receiver can store up to 4 dif-
ferent transmitter codes in memory. Use the following learn routine to add transmitters to the system or to
change button assignments if desired.
The Program switch, plugged into the blue port, is used for programming. There is a basic sequence of steps to
remember whenever programming this unit: Key, Choose, Transmit and Release.
1.
Key.
Turn the ignition to the ON position.
2.
Choose.
Within 10 seconds, press and release the Program switch the number of times cor-
responding to the desired channel listed below. Once you have selected the channel, press
the switch once more and
HOLD
it. The LED will flash to confirm the selected channel. Do
not release the Program switch.
auto learn transmitter configuration
/
button one .......................lock/unlock
button two .......................Channel 2
OPT
button three .....................No function
button four.......................remote engine start
/
+
buttons one and two..........timer mode
/
+
buttons one and four .........turbo start/short run
/
+
+
buttons one, two and four ....rear defogger on/off
