Please configure the IP Dome Camera at the location of its installation. You must determine your network scenario in
order to configure the IP Dome Camera with the proper TCP/IP settings. This tutorial will guide you through the process.
Before actually configuring the IP Dome Camera, determine what settings you will apply. Record those settings that you
will use to configure your IP Dome Camera for reference.
When configuring your IP Dome Camera, treat the IP Dome Camera as another PC on your network. You will assign it
several addresses and other TCP/IP properties to match your current network.
This step-by-step tutorial will teach what IP addresses and network configurations you should assign your IP Dome Camera
based upon your network scenario.
Guide to Network Environment
Before you begin, you will need to locate any information and settings that you have received from your Internet
Service Provider(ISP). You may need to refer to these IP addresses at a later time during the configuration.
•
If you were not given any IP addresses or the ISP was responsible for the setup and installation of your Internet
connection on your PC or network, then please go to step 2.
If you are not using a router on your network, your
Current TCP/IP Settings(from the previous section) and
Assigned IP Addresses from My ISP will be exactly the same.
"
"
"
"
i
i
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server (Option)
Assigned IP Address
Static
Dynamic
PPPoE
You must determine whether the IP address that you were assigned from the ISP is STATIC, DYNAMIC, or using PPPoE. At
this moment, you are only concerned about the ISP. Did they provide you with a STATIC, DYNAMIC, or PPPoE address? If
you are unsure, please contact your ISP.
•
Configure your IP Dome Cameras TCP/IP settings for network connectivity by selecting Administration Tools from the
main interface and selecting TCP/IP located on the left of the Administration Tools screen.
If prompted for an ID and Password, use adminfor both entries.
The default web port number is 80. If your ISP blocks port 80 you must use a value between 1025-30000. Please consult
your ISP and determine if they block TCP port 80.
Depicted below are several basic network scenarios. Determine which scenario describes your network. If your
network does not match one of the scenarios below and are unsure how to setup your IP Dome Camera, please contact
your network administrator, then call our Support Center.
'
"
"
•
•
•
Dash line box signifies areas of tour network that you can't control.
Only the ISP has access to these devices.
i
4
NETWORK SETUP
17/52
CISEYE
Indoor IP Dome Camera
Users Manual
