Quick Start of Network Connection
Please follow the steps below to complete the initial setup of the Network Function.
You will need to access a PC/laptop and should configure that PC in order to communicate with the IP Dome Camera.
Record the current TCP/IP properties of that PC(IP address, subnet mask, gateway, DNS, etc).
•
Configure the IP Dome Camera's TCP/IP settings as you would any other PC on your network, providing a proper IP
address, subnet mask, default gateway, and DNS server.
•
Change the IP address of that host PC to 192.168.1.11 and subnet mask to 255.255.255.0(leave all other entries
blank).
Connect the IP Dome Camera to your PCs Ethernet port via the supplied crossover cable(it does not matter what
end is used for the PC).
Power on the IP Dome Camera.
After 50 seconds of power, verify a flashing ACTIVE indicator and a flashing or solid LINK indicator. After the
corresponding indicator lights are properly displayed, open Internet Explorer.
Type - http://192.168.1.80(the default IP of the IP Dome Camera) into your address bar.
Default ID/Password to access camera are both the word: admin.
Familiarize yourself with the Viewer Interface Screen.
Locate the TCP/IP configuration under Administration Tools. Supply the same ID and Password to enter Administration
Tools(admin:admin).
Under Network Type select STATIC. You will only select Dynamic or PPPoE if you are connecting the IP Dome Camera
directly to your cable/DSL/Broadband modem and your Internet Service Provider is supplying you a dynamic or PPPoE
address.
'
"
"
•
•
•
•
•
•
•
•
•
If you have a network with other devices(such as PC/laptop, etc.) or a router, you will NEVER select Dynamic or
PPPoE.
Please do not power on the IP Dome Camera until instructed.
Temporarily disable any proxy servers configured in Internet Explorer.
If connecting the IP Dome Camera directly to a modem, power down and reset the modem.
Leave the modem powered down until configurations are finalized with the IP Dome Camera and the IP Dome
Camera has been correctly connected to the modem.
i
If your PC obtains its IP address automatically, then there is no need to record any information.
i
i
If this is standalone unit with a direct connection to a cable/DSL/Broadband modem then input the addresses you
have received from your ISP. If you received no IP address from your ISP, please select Dynamic or PPPoE and choose
the proper settings.
i
3
INSTALLATION
13/52
CISEYE
Indoor IP Dome Camera
Users Manual
