Cisco MCS-7825-H3-IPC1, Руководство по обслуживанию

Страница: 936 / 974

8-132
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 8 Industry-Standard Management Information Base
IF-MIB
SYNTAX INTEGER { notInUse(1), inUse(2) }
MAX-ACCESS read-write
STATUS deprecated
DESCRIPTION
This object indicates whether or not some manager currently has the necessary 'ownership' required
to invoke a test on this interface. A write to this object is only successful when it changes its value
from 'notInUse(1)' to 'inUse(2)'. After completion of a test, the agent resets the value back to
'notInUse(1)'.
::= { ifTestEntry 2 }
ifTestType OBJECT-TYPE
SYNTAX AutonomousType
MAX-ACCESS read-write
STATUS deprecated
DESCRIPTION
A control variable used to start and stop operator-initiated interface tests. Most OBJECT
IDENTIFIER values assigned to tests are defined elsewhere, in association with specific types of
interface. However, this document assigns a value for a full-duplex loopback test, and defines the
special meanings of the subject identifier:
noTest OBJECT IDENTIFIER ::= { 0 0 }
When the value noTest is written to this object, no action is taken unless a test is in progress, in
which case the test is aborted. Writing any other value to this object is only valid when no test is
currently in progress, in which case the indicated test is initiated.
When read, this object always returns the most recent value that ifTestType was set to. If it has not
been set since the last initialization of the network management subsystem on the agent, a value of
noTest is returned.
::= { ifTestEntry 3 }
ifTestResult OBJECT-TYPE
SYNTAX INTEGER { none(1), -- no test yet requested success(2), inProgress(3),
notSupported(4), unAbleToRun(5), -- due to state of system aborted(6), failed(7) }
MAX-ACCESS read-only
STATUS deprecated
DESCRIPTION
This object contains the result of the most recently requested test, or the value none(1) if no tests
have been requested since the last reset. Note that this facility provides no provision for saving the
results of one test when starting another, as could be required if used by multiple managers
concurrently.
::= { ifTestEntry 4 }
ifTestCode OBJECT-TYPE
SYNTAX OBJECT IDENTIFIER
MAX-ACCESS read-only
STATUS deprecated
DESCRIPTION