Cisco MCS-7825-H3-IPC1, Руководство по обслуживанию

Страница: 507 / 974

6-273
Cisco Unified Communications Manager Managed Services Guide
OL-22523-01
Chapter 6 Cisco Unified Serviceability Alarms and CiscoLog Messages
Warning-Level Alarms
This can be done only in the Media Resource Group List and not in the Default List of the media
resources. In any Media Resource Group List all the Media Resource Groups have different priorities;
during allocation the first Media Resource Group is always checked for availability of the requested type
of the media devices. The first Media Resource Group in the Media Resource Group List will have the
highest priority, then the second one, and so on.
To check all the Media Resource Groups and their priority go the Media Resources and Media Resource
Group List of Cisco Unified CM Administration page and click the appropriate Media Resource Group
List and check the Selected Media Resource Groups; the priority decreases from top to bottom. So, the
MTP or transcoder that you want to be selected for the most basic functionalities should be positioned
in the higher priority Media Resource Groups whereas the ones with more rare functionality should be
positioned in the Media Resource Groups with lower priority. MTP/transcoder allocation may fail due
to codec mismatch between the endpoint and the MTP/transcoder.
A solution may be to configure the MTP/transcoder with all the supported codecs (as specified in the
user guide of the MTP/transcoder), but be aware that doing so might result in too much bandwidth being
allocated for calls. You'll need to weigh different factors such as the total amount of available bandwidth,
the average number of calls, approximate bandwidth use per call (not involving MTP/transcoder), and
so on, and accordingly calculate the maximum bandwidth that can be allocated per call involving an
MTP/transcoder and take that into consideration when configuring the supported codecs in the MTPs
and transcoders. A good idea is to configure the media devices with all the supported codecs and set the
region bandwidths to restrict too much bandwidth usage (refer to the Unified CM documentation for
details on region and location settings).
Also, there may be a codec mismatch between the endpoint and the MTP/transcoders after considering
the region bandwidth between the MTP/transcoder and the endpoint. Increasing the region bandwidth
may be a solution to the problem, but again, that decision should be made after careful consideration of
the amount of bandwidth you're willing to allocate per call between the set of regions. Another possible
cause that an MTP/transcoder did not get allocated is because there was not enough available bandwidth
for the call.
This can happen if the MTP/transcoder and endpoint belong to different locations and the bandwidth that
is set between the locations is already in use by other calls. Examine the bandwidth requirements in your
deployment to determine whether bandwidth between the locations can be increased.
However, please note that increasing the bandwidth between these two locations means that you may
need to reduce the bandwidth between other locations. Refer to the System Guide, SRNDs, and related
Unified CM documentation for more details. Be aware that reducing the bandwidth or removing the
higher bandwidth codecs from configuration may result in poor voice quality during call. Consider
increasing the total amount of network bandwidth available. Finally, if MTP or transcoder allocation
fails due to capability mismatch or all the resources being in use, consider installing additional MTP or
transcoder devices.
MTPDeviceRecoveryCreateFailed
MTP device recovery create failure. An error was encountered trying to restart the Media Termination
Point device. This may be due to a shortage of application memory.
History
Cisco Unified Communications
Release
Action
8.0(1) Changed severity level from Error to Warning and added existing
Routing List elements and Parameters.