Chapter 1
Product Overview
4
Media Hub
To replace a hard disk, follow these instructions:
1. To shut down the Media Hub, press and hold the Power
button until the Power LED starts flashing.
If this step does not shut down the Media Hub, then
proceed to step 2.
2. Disconnect the power adapter from the Power port.
3. Disconnect the Ethernet network cable from the
Ethernet port.
4. To release the drive bay cover, push the button on the
top panel.
5. To remove the hard disk you want to replace, push
together the clips of its drive bay, and then pull out
the drive bay.
6. Remove the hard disk from its drive bay.
7. To install the replacement hard disk, make sure the
screw holes of the hard disk line up with the screw
holes of the drive bay. Then insert the hard disk into
the drive bay.
8. Use the four included screws to secure the hard disk
in its bay.
9. With the hard disk’s label facing the right side of the
Media Hub, slide the drive bay back into its slot.
10. Push down on the hard disk to make sure the
connectors are securely seated.
11. Lower the cover, and push it down to secure it.
12. Connect the Ethernet network cable to the Ethernet
port.
13. Connect the power adapter to the Power port.
