Cisco CDB-8P, Руководство по установке

Страница: 29 / 110

Bluetooth Version Chipset Manufacturer Chipset
Bluetooth 4.0 and above
Dual-Mode Dongle Qualcomm/Cambridge Silicon Radio
(CSR) CSR8510
Broadcom BCM20702
• USB flash drives with capacities from 128MB to 8GB are supported.
• Up to 2GB of Cisco SD memory card is supported.
General Guidelines
When determining where to install the switch, verify that these guidelines are met:
• The operating environment is within the ranges listed in Technical Specifications .
• Clearance to the switch front and rear panel meets these conditions:
◦ Front-panel LEDs can be easily read.
◦ Access to ports is sufficient for unrestricted cabling.
◦ AC power cord can reach from the AC power outlet to the connector on the switch mount.
◦ At least 3" clearance above cooling fins is provided.
• Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent lighting
fixtures. Make sure that the cabling is safely away from other devices that might damage the cables.
• Airflow around the switch is unrestricted.
• For 10/100 and 1-Gigabit Ethernet ports, the cable length from a switch to a connected device cannot
exceed 328 feet (100 meters).
Rack Mounting Guidelines
• 5RU 19" rack mount chassis (CDB-MNT-RACK5-C14) can only be installed in standard 19-inch racks.
• 19" rack mount chassis can be installed with wiring box up or down for cable routing.
• A gap of 2 RU must be provided between each rack unit for ventilation unless forced air is provided top
to bottom in the rack.
• The rack mount chassis can have a mix of CDB-8P and CDB-8U units, as long as power cords are
plugged into a power source with sufficient ampacity.
• Switches will power up on insertion. Remove and re-insert to power cycle when direct wired, or cycle
at breaker.
• Switches can be hot-swapped.
Catalyst Digital Building Series Switch Hardware Installation Guide
19
Switch Installation
Installation Guidelines