GE AC Instalation and operation manual V10.docx
19
/ 63
(X10)
Earth connection terminal for EUT (
).
(X11)
DB9 connector for RS485 communications.
(X12)
Terminals for external Emergency Power Off (EPO) button.
(X13)
DB9 connector for CAN communications (input).
(X14)
DB9 connector for CAN communications (output).
(X15)
RJ45 connector for MODBUS interface.
(X16)
DE15 connector for digital inputs and outputs.
(X17)
DE15 connector for analogic inputs and outputs.
In case of discrepancies between labelling and this manual instruction, the label
information will always prevail.
Equipment reception
3.3.1.
Unpacking and checking the content
On receiving the device, make sure that the power supply has not suffered any damage during
the transportation. Otherwise, make all pertinent claims to the supplier or to CINERGIA.
The packing of the device consists of a wooden palette, a cardboard or wooden packaging
(depending on the case), expanded polystyrene corner pieces, a polyethylene sleeve and bands;
all recyclable materials. Therefore, they should be disposed of according to current regulations.
We recommend to keep the packaging in case its use is necessary in the future.
In order to unpack, cut the bands and remove the cardboard packaging with a vertical
movement. In case of wooden packaging, remove it with the appropriate tools. Afterwards,
remove the corner pieces and the plastic sleeve. At this point the equipment will be unpacked
on the pallet. Please, use suitable tools to lower the power supply from the pallet.
After unpacking the equipment, check that the data in the nameplate (stuck on the inner part
of the front door) correspond to those specified in the purchase order. Contact the supplier or
CINERGIA in case of disconformity.
Keep the equipment in the original package if it will not be used in order to protect it from any
possible mechanical damages, dust, dirt, etc…
3.3.2.
Storage
The equipment shall be stored in a dry, ventilated place and protected against rain, water jets
or chemical agents. It is advisable to keep the power supply into its original package, which has
been designed to assure the maximum protection during the transport and storage.
Do not store the unit where the ambient temperature exceeds 40ºC or falls
below -20ºC
