Cincinnati Sub-Zero HEMOTHERM 400CE, Руководство по эксплуатации, Страница: 66 / 95

OPERATION MANUAL HEMOTHERM MODEL 400CE
Page 19 of 46
Reference Figures 1-2, 1-3, 1-4, & 1-5 Keypad Views
1. TEMPERATURE DISPLAY WINDOWS
– Left side indicates heat reservoir temperature.
Right side indicates cool reservoir temperature. This display is also used to display the
set point temperature when the control is in the temp set mode.
2. HEATER STATUS LIGHTS
– When illuminated these indicate that the controller is
signaling the heaters to be on. These lights will not indicate a heater that is
malfunctioning or inoperative due to a burned out heater element or wire break.
3. TEST INDICATORS BUTTON
– When pressed this button will turn on all of the keypad
indicators and test the audible alarm.
4. SILENCE ALARM BUTTON
– When pressed this button will temporarily silence the
alarm if it is not a Remove from Service (RFS) issue.
5. LOW TEMP LIMIT LIGHT
– When illuminated the cool reservoir temperature is lower
than should be allowed by the safety limits.
6. COOL LOW WATER LIGHT
– When illuminated water needs to be added to the cool
reservoir.
7. COOL MODE BUTTON / LIGHT
– When pressed this button along with the pump
button will start the cool reservoir conditioning to obtain the indicated set point
temperature. The light will be illuminated when the unit is in cool mode.
8. COOL DECREMENT BUTTON
– When pressed this button will decrease the
temperature set point indicated on the cool temperature display.
9. COOL TEMP SET BUTTON
– When pressed this button will indicate the desired set
point temperature of the cool reservoir on the cool temperature display.
10. COOL INCREMENT BUTTON
– When pressed this button will increase the
temperature set point indicated on the cool temperature display.
11. COOL INSTRUCTIONS
– Abbreviated instructions on how to adjust and set the cool
reservoir temperature. To completely understand the operation of the unit, consult
appropriate sections in this manual.
12. PUMP BUTTON
– When pressed this button will turn on the pump that circulates water
in and out of the unit. This button must be pushed after the cool button is pushed if you
want to cool the water in the cool reservoir or for unit preconditioning. The pump does
not need to be on to allow the heaters to come on. The light will be illuminated when
the controller is signaling the pump to operate.
13. HEAT INSTRUCTIONS
– Abbreviated instructions on how to adjust and set the heat
reservoir temperature. To completely understand the operation of the unit, consult
appropriate sections in this manual.