25
Plus 42 - 45 - 50 - 55 - 55S - 55E
11-2000
3 – Connect the distribution piping T7 to the
hydraulic circuit of the distribution device
(head) mounted on the machine (follow the
instructions of the specific “use and mainte-
nance” booklet which is supplied with it).
Position the distribution piping T7
and feed piping T6 so as to avoid the
risk of suffering damage or breakage
during treatments.
If necessary, utilise suitable securing
clamps.
IN CASE OF BREAKAGE:
1 – Stop the tractor and remove the key from the
control panel.
IThe mains cable “W1” is provided
complete with mains socket to be
mounted on tractors that might not
be equipped with it, or to replace the
existing one should it be incompati-
ble with the plug.
4. Connect the distribution piping T7 to the
hydraulic circuit of the distribution device
(head) mounted on the machine (follow the
instructions of the specific “use and mainte-
nance” booklet which is supplied with it).
Position the electrical cables W1 and
W2 in such a way as to avoid risking
their being wrenched off during treat-
ments. If necessary, utilise some se-
curing clamps.
A sudden interruption of power will
lock the 2 solenoid valves of the electri-
cal distributor “E11”. Should this fault
take place when they are in the open
position, it is necessary to:
- Stop the tractor and remove the key
from the control panel.
- Position tap P5 on “d”..
00085
ELECTRICAL
CONTROL
PANEL
TO THE SERVICE
SOCKET
SECURING
BRACKET
W2
E10
W1
00086
E7
00084
ECURING
BRACKET
MANUAL
DISTRIBUTOR
BAYONET
SUPPORT
T7
P10
T6
2 – Close the 2 taps of distributor “P10”.
3 – Place the lever of the 3-way tap “P5” in position “d”.
5.3.2 - Electrical control panel - E10
1 – Mount the securing clamp on the tractor within the driver’s reach.
2 – Insert the bayonet support of the control panel in the securing clamp.
3 – Connect the mains cable “W1” inserting the plug into the mains socket of the tractor.
TO THE ELECTRICAL
DISTRIBUTOR (E7)
