31
Plus 42 - 45 - 50 - 55 - 55S - 55E
11-2000
8.1.b Latching of the fan to perform the treatment
EXECUTION:
1. Disengage the power take off (PTO) and rest the machine on the ground.
2.
Stop the tractor, remove the key from the control panel and check that
the fan is stopped.
3. Undo the mobile protection cap’s fixing screw and rotate it so as to access the disengagement
tunnel.
4. Fully press the spring push button, push the front body forward, if necessary, turning it to the right
or left, until the frontal teeth of the joint engage the corresponding teeth of the pulley; at the same
time, the spring push button must return to the outward position. This way, the body is again
integrated with the pulley, thus transmitting the movement to the fan.
5. Reposition the mobile protection cover and suitably tighten the securing screw.
6. Start the tractor and lift the spray atomiser to position the universal joint shaft.
8.2 - FILLING OPERATION THROUGH POURING FROM THE TOP
For this type of filling, utilise the supplementary filler (BS) located in the upper
right-hand side of the tank, towards the front of the spray atomiser (opposite the
filler of the hand washing tank).
THE INLET OF THE FILLER PIPING MUST NEVER COME INTO CONTACT WITH THE ANTI-
PARASITIC MIXTURE: IT MUST ALWAYS BE KEPT AT A SAFE HEIGHT ABOVE THE TANK
FILLER AND MUST BE EQUIPPED WITH A NON-RETURN VALVE.
THE PUMP MUST NEVER RUN DRY
EXECUTION:
1. Disengage the fan: see point 8.1.a.
2. Close the taps of the 2-way distributor:
a. if manual (P10), set the levers in the horizontal position;
b. if electrical, position the latch switches (E10).on “OFF”
3. Check that taps
- P2 and P3: are open (lever in the “a” position);
- P5: is in the working position (lever on “a”);
- P6: is open (working position). NOTE: upon the first filling of the spray atomiser CHECK that the
pressure regulator is in the OPEN position;
- P7: is closed (lever in the “c” position);
- P8: filter knob tap is closed.
4. Pour water in the tank to about 1/3 capacity through the supplementary filler BS.
5a.
FILLING WITH POWDER PRODUCTS BY UTILISING THE MIXER
5a1. Pour the dose of the medicinal in powder form into the cup-like filter through the main filler (BP)
5a2. Close the tank’s main filler (BP)
5a3. Open the filter’s knob tap (P8)
5a4. Set the lever of tap (P5) to the “b” position
