Christie Roadster HD14K-J, Руководство пользователя, Страница: 29 / 182

Section 2: Installation and Setup
J Series 2.0, 2.4, and 3.0kW User Manual 2-15
020-100707-01 Rev. 1 (10-2011)
4. Loosen the rear stacking leg nuts
On the rear stacking legs ( Figure 2-19 ), loosen
the nuts so the legs have some lateral
movement for easier alignment with the
stacking mounts on the other projector.
• If upright, release on top projector
• If inverted, release on bottom projector
5. Release and remove three safety pins.
The 3 safety pins must be removed from the stacking mounts so that
the stacking legs can fit into the mounts (
Figure 2-20 ).
• If upright, remove the pins from the mounts on the bottom projec-
tor
• If inverted, remove the 3 safety pins from the mounts on the top
projector
6. Place top projector on bottom projector.
With 1 person on each side, lift the top projector on to the bottom
projector, aligning all 3 stacking points between projectors. The legs
(4) should fit inside the stacking mounts.
Minimum of 2 people required.
7. Align the holes in the 3 stacking mounts and 3 stacking legs.
On each stacking mount, turn
the adjusting wheel slightly
until the hole in the top portion
of the mount lines up with the
hole in the stacking leg (
Figure
2-21 ).
NOTE:
You can
increase leverage by using a
screwdriver in the holes.
8. Insert 3 safety pins and LOCK all.
Figure 2-19 Loosen 2 Nuts
Figure 2-20 Remove Safety Pins
Figure 2-21 Align Holes in Mounts and Legs, and LOCK with Pin