Christie Roadster HD14K-J, Руководство пользователя, Страница: 124 / 182

4-10 J Series 2.0, 2.4, and 3.0kW User Manual
020-100707-01 Rev. 1 10-2011
Section 4: Web User Interface
T
O
A
DD A
S
CHEDULED
E
VENT
1. Click Add to open the RTE Wizard .
2. Select the Scheduled Event tab.
NOTE:
The scheduled tab is always selected by default on add.
F
IGURE
4-14 S
CHEDULED
E
VENT
W
INDOW
3. Select the frequency option for the event by selecting either Once , Daily , Weekly , or Monthly .
NOTE:
End Date is enabled when Daily, Weekly or Monthly repeat options are selected.
4. Click within the Start Time field to open a calendar pop-up window.
5. Navigate to and select a desired date. The selected date will populate the Start Time field.
6. In the field below the Start Time field, enter a start time in the format “hr:min:sec”. The default is the
current time.
7. Click Sync to set the computer and projector time to be the same; otherwise, the event will run based on
the projector time.
NOTE:
Synching the projector time to be that of your system time.
8. Enter a description of the scheduled event in the Description field.
NOTE:
Maximum of 100 characters.
9. Enter a serial command or a sequence of serial commands, with which you wish the projector to perform in
the Command String box.
• If a GPIO command string is needed, click the GPIO Output Helper button for instructions on how to
create the command structure.
NOTES: 1)
The Output field contains 7 blocks which refer to the 7 I/O
pins on the GPIO connector. Pin 1 = +12V and Pin 5 = Ground. These are not included.
2)
Clicking a
block toggles between H, L, and X.
3)
If the Pulse check box is selected, those I/O Pins defined will
pulse high or low. See Figure 4-15 GPIO Output Helper . See Appendix B: for detailed information.
F
IGURE
4-15 GPIO O
UTPUT
H
ELPER
•
NOTE
: Serial Representation box is read only.
• Click the Help button for a description of special RTE commands available for adding loops and delays
to the command sequence.