Christie CineIPM-2K, Руководство пользователя

Страница: 23 / 122

INSTALLATION AND SETUP
Cine-IPM 2K User’s Manual 2-17
020-100164-01 Rev. 1 (01/08)
need help changing the projector baud rate. In addition, set the Network Routing to
“RS232 and RS422 Joined” if you want to reach all
Cine-IPM 2K / CP2000 sets.
NOTES: 1)
To avoid damage, connect only properly wired serial communication
cables. See Appendix C for details.
2)
It is recommended that each RS232
communication cable be no more than 25 feet in length. Use high quality cables.
ETHERNET NETWORK SETUP
: To add one or more Cine-IPM 2Ks to an Ethernet
network, use standard CAT5 cable to connect each unit’s front Ethernet port to a hub
belonging to the network. A controller or PC must also be connected to the hub. See
Figure 2.23.
Figure 2.23. Typical Ethernet Network
SETTING THE Cine-IPM 2K’s IP ADDRESS
: By default, a DHCP server (if present) will
automatically assign a valid and unique IP address for each Cine-IPM 2K present,
upon connection to most Ethernet networks. Depending on the network, this DHCP-
assigned IP address usually remains stable for the current session, but may change
with subsequent power-ups and logins. On some networks, the address will even
remain stable from session to session. In all cases, the
Cine-IPM 2K’s IP address and
port appear in the Status menu as well as the Ethernet Settings submenu.
Figure 2.24. Setting the Cine-IPM 2K’s IP Address
If you have no DHCP server on your network, or if you simply wish to assign a
specific static address, enter this address in the
Ethernet Settings submenu or send it
to the Cine-IPM 2K via a serial command. The unit will respond immediately and
permanently to commands sent to this address until you enter a new address, or until
you re-enable the DHCP auto-assign checkbox.
Ethernet Networks X