Christie CineIPM-2K, Руководство пользователя

Страница: 32 / 122

OPERATION
3-6 Cine-IPM 2K User’s Manual
020-100164-01 Rev. 1 (01/08)
Input 1
Press
Input 1 to display from the data input source connected to BNCs labeled
INPUT 1
.
If PIP is enabled, pressing this key will change the PIP source.
Input 2
Press
Input 2
to display from the DVI source (analog or digital) connected to
INPUT 2
. If
PIP is enabled, pressing this key will change the PIP source.
Input 3
Press
Input 3
to display from the composite video source connected to
INPUT 3
. If PIP is
enabled, pressing this key will change the PIP source.
Input 4
Press
Input 4
to display from the S-video source connected to
INPUT 4
. If PIP is
enabled, pressing this key will change the PIP source.
Input 5
Press
Input 5
to display from the
INPUT 5
interface module installed in the Option 1 slot.
If PIP is enabled, pressing this key will change the PIP source. If the Dual SD/HD-
SDI Module is installed here, with two inputs connected to it, the second input (B) is
considered
INPUT 7.
Use
INPUT 5
to access
INPUT 7
as follows:
•
While displaying from
INPUT 5
, press
Input 5
again. This switches to
INPUT 7
.
•
While displaying from any input other than the Dual SD/HD-SDI Module ,
press
Input 5
. This switches to either
INPUT 5
or
INPUT 7
, depending on which of
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
Input 5 again
to display from the other Dual SD/HD-SDI Module input.
Input 6
Press
Input 6
to display from the
INPUT 6
interface module installed in the Option 2 slot.
If PIP is enabled, pressing this key will change the PIP source. If the Dual SD/HD-
SDI Module is installed here, and there are two inputs connected, its second input (B)
is considered
INPUT 8
. Use
INPUT 6
to access
INPUT 8
as follows:
•
While displaying from
INPUT 6
, press
Input 6
again. This switches to
INPUT 8
.
•
While displaying from any input other than the Dual SD/HD-SDI Module ,
press
Input 6
. This switches to either
INPUT 6
or
INPUT 8
, depending on which of
the Dual SD/HD-SDI Module inputs (A or B) was last used. Press
Input 6 again
to display from the other Dual SD/HD-SDI Module input.
Contrast
Press
Cont
to change the amount of white in your images. Use keys until
you reach the desired level of white—for best results, start low and increase so that
whites remain bright but are not distorted or tinted, and that light areas do not
become white (i.e., “crushed”). Conversely, low contrast causes dim images. See
3.5
Adjusting the Image (Image Settings subsection) .
Brightness
Press
Bright
to increase or decrease the amount of black in the image. Use
keys until you reach the desired level of black—for best results, start high and
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Cont
Bright